SERVICING
This product should be serviced by an authorized engineer and only genuine spare parts should be used.
Under no circumstances should you attempt to repair the appliance yourself.
Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact the local
store where your purchase was made.
When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods
and clean the appliance, leaving the door ajar to prevent unpleasant smells.
CHANGING THE LAMP
The LED lamp is used by the refrigerator for lighting, which features low energy consumption and long service
life. In case of any abnormality, please contact the after-sales personnel for visiting service. The LED lamps can
only be replaced by the after-sales personnel.
Replaceable (LED only) light source by a professional
This product contains a light source with no energy efficiency class
CLEANING AND CARE
For hygienic reasons the appliance (including exterior and interior accessories) should be cleaned regularly at
least every two months.
WARNING: The appliance must not be connected to the mains during cleaning. Danger of electrical shock!
Before cleaning, switch the appliance off and remove the plug from the mains socket.
Exterior cleaning
•
To maintain good appearance of your appliance, you should clean it regularly.
•
Spray water onto the cleaning cloth instead of spraying directly on the surface of the appliance. This helps
ensure an even distribution of moisture to the surface.
•
Clean the doors, handles and cabinet surfaces with a mild detergent and then wiped dry with a soft cloth.
Caution!
Don't use sharp objects as they are likely to scratch the surface. Don't use Thinner, Car detergent, Clorox,
ethereal oil, abrasive cleansers or organic solvent such as Benzene for cleaning. They may damage the surface
of the appliance and may cause fire.
Interior cleaning
You should clean the appliance interior regularly. It will be easier to clean when food stocks are low. Wipe the
inside of the appliance with a weak solution of bicarbonate of soda, and then rinse with warm water using a
wrung-out sponge or cloth. Thoroughly dry all surfaces and removable parts.
Door seals cleaning
Take care to keep door seals clean. Sticky food and drinks can cause seals to stick to the cabinet and tear when
you open the door. Wash seal with a mild detergent and warm water. Rinse and dry it thoroughly after cleaning.
Caution! Only after the door seals are completely dry should the appliance be powered on.
DOOR REVERSE
Users can change the direction of opening according to one's own needs. The concrete operating sequence is as
follows: (The pictures below are for the guideline to reverse the door. The appearance of the appliance may be
different from the product you purchased.)
1.
Make sure that your refrigerator is unplugged.
2.
Remove the hinge cover and upper hinge from the top right side of the cabinet. Remove the screw hole
cover from the top left side of the cabinet.
- 11 -