Emerio SDR-129286 Manual De Instrucciones página 9

Heat dissipation space
When working, the refrigerator gives off heat to surroundings. Therefore, at least 30mm of free space should
be spared at the top side, more than 100mm on both sides, and above 50mm at the back side of the refrigerator.
Dimensions in mm
W D
470 447
Figure 1
Note: Figure 1 and Figure 2 only as a product space demand size schematic diagram.
Leveling the appliance
If the appliance is not level, the door and magnetic seal alignment will be affected and may cause the appliance
to work incorrectly. Once the appliance is placed in its final location, adjust the leveling feet at the front by
turning them.
Cleaning before use
Wipe the inside of the appliance with a weak solution of bicarbonate of soda. Then rinse with warm water using
a damp sponge or cloth. Wash the shelf (shelves) in warm soapy water and dry completely before replacing in
the appliance.
Before plugging in
Check that you have a socket which is compatible with the plug supplied with the appliance.
Before switching on
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE APPLIANCE.
The coolant fluid needs time to settle. If the appliance is switched off at any time, wait 30 minutes before
switching back on to allow the coolant fluid to settle.
Before filling your appliance
Before storing foods in your appliance, turn the appliance on and wait for 24 hours, to make sure it is working
properly and to allow the appliance to fall to the correct temperature.
START
Testing
Clean the parts of the appliance with lukewarm water containing a little neutral detergent and with clear water,
and wipe them dry.
Notes: Electric parts of the appliance can only be wiped by dry cloth.
1. Remark: turn the temperature control dial to position "4" to turn on the electricity. The compressor begins
to work.
2. Open the door 30 minutes later, if the temperature in the refrigerator decreases obviously, it shows that
the refrigerator system works well.
H A B
831 800 874
Figure 2
C (°) E
130±5 50
- 8 -
F
100