Diagrama Eléctrico; Routine Inspection; Consejos Generales; Operation - Skymsen SI-282HD Manual De Instrucciones

4. 2. 1 Danger
The electric cord or any electric wire if damaged may cause electric shock .
Before to use them be sure they are in perfect conditions.
4. 2. 2 Notices
Be sure that the Instructions given in the Instruction Manual have been perfectly
understood. Each function or operation process must be perfectly clear.
Before operating a Manual Command (button, switch etc), be sure the
command is the right one.
4. 2. 3 Cares
The electricity supply source shall have the right size to support the current
required by the Band Saw electric motor .
Any electric cable lying on the floor, or near the Band Saw, must be well
protected to avoid short circuits.

4. 3 ROUTINE INSPECTION

4. 3. 1 Notice
When checking the Belt tightness be careful to not have a finger caught
between the Belt and the Wheel.
4. 3. 2 Cares
When abnormal noises are heard, check the electric motor or any sliding or
rotating part of the saw.
Check from time to time the Belt tightness, change the Belt if it is worn out.
Check safety and protections devices to have them always in good working
conditions.

4. 4 OPERATION

4. 4. 1 Notices
Do not work with loose long hair, that could touch any part of the Band Saw,
because they may cause serious accidents. Thigh them behind and above the head, or
cover them with a scarf.
Only qualified and well trained operator may operate the Band Saw.
NEVER operate the Band Saw, without any one of its safety devices.
09
-Con la llave fija de 13mm gire el Tornillo Nº02 (Fig.02) en el sentido ante-horario si la Hoja Nº09 (Fig.01)
estuviera inclinada para atrás, o gire el Tornillo en el sentido horario si la Hoja Nº09 (Fig.01) estuviera
inclinada para frente.
-Apriete la Tuerca Nº01 (Fig.02) con la referida llave.
-Calibre la Hoja conforme descrito en 5.2.1.
-Gire manualmente el Volante y verifique si la Hoja está centralizada en el mismo. Proceda de esta
forma hasta que la Hoja esté centralizada.
Figura - 02
01

6. CONSEJOS GENERALES

- Do not wear loose fitting clothes while operating the unit. Do not use bracelets or any other piece of
jewelry. Have your hair always shortened and held up (use hair fishnets if necessary) in a way it
cannot reach any part of the machine. Roll up any loose sleeves.
- SKYMSEN is not responsible for any harm or injury caused by the negligent or inappropriate use of
this equipment by any operator. This equipment must be operated only by persons whose age equals
or exceeds 18 years old, in a safe and sound state of mind, free from the influence of any kind of drugs
and alcohol, that received proper training and instructions regarding the correct operation of this
machine, that are wearing correct and authorized safety clothes. All and any kind of modifications
carried on and applied to this machine immediately nullifies any kind of warranty and may result in
harm and injuries to the individuals operating this machine and to individuals that are located in the
machine surrounding areas while it is being operated.
- Under no circunstances place your hands in the moving parts of the machine while it is being used.
Make sure the machine has come to a complete stop before acessing the processed ingredients.
5.3 Diagrama Eléctrico
Llave Prende/Desliga
02
Contactora
Llave de Emergencia
Motor
26