Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Hanging the Fan (continued)
7
Mounting the fan-motor assembly
(standard mount)
WARNING: When using the standard ball/downrod mounting,
the tab in the ring at the bottom of the mounting bracket
must rest in the groove of the hanger ball. Failure to properly
seat the tab in the groove could cause damage to the wiring.
□
Align the locking slots of the canopy (C) with the two
screws (II) in the mounting bracket (A). Push up to engage
the slots and turn clockwise to lock in place.
□
Firmly tighten the two mounting screws (II).
□
Install the two canopy screws (HH) (saved from Assembly
Step 1 "Preparing for mounting") into the holes in the
canopy (C) and tighten firmly.
□
Install the decorative canopy ring (FF) by aligning the
ring's slots with the screws in the canopy (C). Rotate the
ring clockwise to lock in place.
Assembly - Attaching the Blades
1
Attaching the post
□
Remove the finial (RR) and rubber pad (NN) from the post (G).
□
Attach the post (G) to the center hole of motor assembly (E)
by turning clockwise. Use an adjustable wrench to completely
tighten the post (G).
2
Attaching the blades
□
Attach a blade (F) to the fan motor assembly (E) by aligning the
three screws holes in the blade with the holes in the center
flywheel and secure with screws (AA).
□
Make sure all the screws are firmly tightened.
□
Repeat these steps for the remaining blades.
G
NN
RR
11
Please contact 1-800-986-3460 for further assistance.
A
B
II
C
FF
D
E
E
G
E
F
AA
HOMEDEPOT.COM/HOMEDECORATORS
Publicidad
