Ducson Star2000 Manual Del Operador página 30

III. OPERATING
3.1. OPERATING CHECKLIST
Operating location
Only use OUTSIDE and place the generating set in a
well-ventilated area.
Only operate the generating set on a flat, level surface
and in a clean, dry operating environment.
Operating engine in the scope of application, and
please consult your local dealers if you have any
question about the application scope.
Please consult your local authority. In some areas,
generating set must be registered with the local utility.
Generating set used to construction sites may be
subject to additional rules and regulations.
DANGER
TOXIC FUMES
The exhaust of the generating set contains carbon
monoxide gas. Using engine indoors CAN| KILL
YOU!
NEVER use inside any building or any kind of
enclosure, EVEN IF doors and windows are open.
Place the generating set in a well-ventilated area and
carefully consider wind and air currents when
positioning generating set.
High altitude
This generating set may require a high altitude
carburetor kit to ensure correct operation at high
altitudes. Consult your local dealer for high altitude kit
information if you always operate your engine at
altitudes above 5,000 feet (1,500 meters).
CAUTION
Even with carburetor modification, generating set
horsepower will decrease about 3.5% for each 1,000
feet (300 meters) increase in altitude. The effect of
altitude on horsepower will be greater than this if no
carburetor modification is made.
www.ducsonpower.com
CAUTION
Operation the engine at altitude below 5,000 feet
(1,500 meters) with modified carburetor may cause
the generating set overheat and result in serious
engine damage.
2. Operating condition
Check for loose or damaged parts, signs of oil or fuel
leaks, and any other condition that may affect proper
operation. Repair or replace all damaged or defective
parts immediately.
WARNING
Failing to correct problem(s) before operation could
result in property damage, serious injury! or DEATH.
Remove any excessive dirt or debris, especially around
the muffler and recoil starter.
DO NOT move or tip the generating set during
operation.
3. Engine oil
Place the engine on a level surface with engine
stopped.
Remove the dipstick and wipe it clean.
Reinstall dipstick into tube; rest on oil fill neck, DO
NOT thread cap into tube.
5