CAUTION
Oil level check
Reinstall dipstick into tube; rest on oil fill neck, DO
NOT thread cap into tube.
4. Fully tighten the dipstick.
5. Dispose of used oil at an approved waste
management facility
Change oil
Change oil when the engine is warm from operation.
1. Place the engine on a level surface.
2. Remove oil dipstick.
3. Remove the oil drain plug and allow the oil to drain
completely.
fully tighten the drain plug.
1. Oil drain plug
2. Dipstick
5. Add recommended oil to the upper limit (see add oil
instruction above).
6. Reinstall and fully tighten the dipstick.
7. Dispose of used oil at an approved waste
management facility
www.ducsonpower.com
Air lter
1. Screw off the filter cover
1. Air filter cover
2. Filter element
2. Remove the paper/foam element.
Paper element: Slightly tapping the element to remove
the dust. Do not wash in water or detergent. Do not
wash in high pressure air.
Foam element: Put the foam element into hot water
with detergent, to throughout dry the element, wrap
and press it in the clean and water sucking fabric.
After cleaning soak it in the clean oil for a while before
wrap and press it in the clean and water sucking fabric
again.
3. Reassemble the element back to the units.
4. Slap the filter cover.
WARNING
DO NOT run the engine without the air filter, serious
danger can Result.
14