Publicidad
Idiomas disponibles
Idiomas disponibles
9. Put in the mounting nut and spacer and tighten them.
5.3
STAND THE MACHINE ON END
Figure 12
1. Remove the grass catcher.
2. Pull and turn the handle knobs 90°.
3. Fold down the handle.
4. Turn the handle knobs 90° to lock the handle into
position.
5. Stand the machine on end and make sure that the brackets
touch the floor.
Storage Switch
The machine has a storage switch that prevents its startup in
the storage position.
It is necessary to remove the safety key and the battery pack
to prevent accidental startup or unapproved use. The storage
switch does not replace this function.
5.4
STORE THE MACHINE
•
Remove the safety key.
•
Remove the battery pack(s).
•
Clean the machine before storage.
•
Make sure the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
6
TROUBLESHOOTING
Problem
Possible cause
The handle is not
The bolts are not
in position.
engaged correctly.
The machine does
The battery ca-
not start.
pacity is low.
The handle switch
is defective.
The safety key is
not put in.
English (Original Instructions)
Solution
Adjust the height
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
Charge the battery
pack.
Replace the handle
switch.
Put in the safety
key.
7
Problem
Possible cause
The machine cuts
The lawn is rough. Examine the mow-
grass unevenly.
The blade height is
not set correctly.
The machine does
Wet grass clip-
not mulch correct-
pings attach to the
ly.
deck.
The mulch plug is
missing.
The machine is
The grass is too
hard to push.
tall, or the blade
height is too low.
The grass catcher
and the blade
drags in thick
grass.
There is a high vi-
The blade is un-
bration in the ma-
balanced and
chine.
worn.
The motor shaft is
bent.
The machine stops
The blade height is
during mowing.
too low.
The battery pack is
out of power.
The grass clip-
pings attach to the
deck or the blade.
Operation temper-
ature of the ma-
chine is too high.
* If you cannot find the solution to these problems, go to the
service center.
7
TECHNICAL DATA
Voltage
No load speed
Cut width
Solution
ing area.
Adjust the blade/
cutting height to a
higher position.
Wait until the
grass dries before
mowing.
Install the mulch
plug.
Increase the blade/
cutting height.
Empty the grass
clippings from the
grass catcher.
Replace the blade.
1. Stop the mo-
tor.
2. Remove the
safety key and
battery pack.
3. Inspect for
damage.
4. Repair the ma-
chine before
you start it
again.
Increase the blade/
cutting height.
Charge the battery
pack.
Remove the bat-
tery pack and
check the deck.
Cool the machine.
82 V
4000 / min
610 mm
EN
Publicidad
