Press the "UP (RST)" button to move to the next test point.
h) STEP 3: TEST THE MOTOR
The motor will rotate the drum by extending the cable and then
i)
Disconnect the battery compartment plug from the printed circuit board (PCB)
to complete the test.
3.4. Cleaning and maintenance
a)
Before cleaning the device, remove the batteries.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all the parts should be dried well before the unit is used
again.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e)
Do not spray the unit with a stream of water or immerse it in water.
f)
Use a soft cloth for cleaning.
g)
Do not leave the batteries in the unit when it will not be used for a long time.
SAFE DISPOSAL OF DISPOSABLE/RECHARGEABLE BATTERIES
The appliances are equipped with AA batteries.
Remove used batteries from the unit in the same way you put them in.
Return the batteries to a unit responsible for their disposal.
DISPOSAL OF WASTE APPLIANCES
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions or packaging. The materials used in this appliance
are recyclable according to their marking. By reuse, recycling or applying other
forms of use of waste machines, you make a significant contribution to the
protection of our environment.
Your local administration will provide you with information about the appropriate
disposal point for used appliances.
TROUBLESHOOTING
Error
Number of
code
flashes
Error 1
0 times every
6 sec.
pulling it back in. If the controller is tested without the door, it is
recommended to tighten the cable slightly by hand (do not use
excessive force and do not block the winding of the cable on the drum
as this may damage the unit).
Reason
No power supply
Solution
Replace the batteries