Publicidad
Idiomas disponibles
Idiomas disponibles
Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Caution:
Do not use brushes which have reached their wear
limit. The wear limit is indicated by the length of the
red bristle. Do not use worn or contaminated pads.
Use original TASKI brushes only.
Failure to observe these instructions may result in inad-
equate cleaning results or even floor damage.
Single- and Double disc Deck
• Position the brush under the brush unit.
• Switch the machine on.
The indicator elements lights up briefly.
Variant: Automatic brush lowering
• Press the Brush drive button ON/
OFF.
While lowering the brush drive will
slowly start to pulse. In this way the
tool is centered and engaged.
The display lights up.
Variant: Foot pedal
• Unlock the foot pedal and lower the
tool slowly.
While lowering the brush drive will
slowly start to pulse. In this way the
tool is centered and engaged.
The brush drive display lights up
Notice:
When the brush is down, gently moving the ma-
chine back and forth can make the clutch easier to
engage.
Roller brush Deck
1
3
5
Orbital Deck
• Press the orbital pad on the pad hold-
er.
Notice:
Make sure that the pad is placed evenly on the pad
holder.
Setting the brush pressure
Manual brush lowering unit
• By operating the lever, the brush
pressure can be adjusted manually.
Notice:
The brush pressure can only be adjusted with the
brush unit raised.
2
4
111
Publicidad
