Descargar Imprimir esta página

Sinbo SHC 4348 Manual Del Usuario página 8

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

REPLACING THE CUTTING HEAD
Switch the appliance off the replaing the cutting head!
If the performance of the appliance deteriorates after extended use,despite the regular
cleaning and maintenance ,the cutting head1 should be replaced (the cutting head can
be ordered as a spare part form the Service Department).First remove the hexagonal
screw on the cutting head 1 by means of the hexagonal spanner attached to the underside
of the charging stand 4 in the direction"__"and remove the old cutting head
(Fig.2.)Important:First remove the screw,then remove the cutting head!Place the new
cutting head on the main body of the appliance screw on place with the spanner
(direction"+").
CLEANING AND MAINTENANCE
Switch the appliance off the before cleanig or carrying out maintenance!
In order to ensure that the appliance remains in perfect working order,it is simportant
to note the following instructions:
In order to retain te load capacity of the storage battery we recommend to use the storage
battery until it is empty before reloading.
Wipe the appliacne with a cloth only (which may be slightly damp,if necessary).No solvents
or lubricants may be used.
After use,take off the clip-on comb attachment and remove any residual hair form the
cutting head with a cleaning brush.
In order to ensure good cutting results and a long life,it is important to oil the cutting
head frequentyly(Fig.3.)
DISPOSING OF THE BATTERY
When you discard your shaver in due course,please remove the battery.Do not throw the
battery away with the normal household waste.But hand it in separately at an officially
assigned collection point.
- 7 -

Publicidad

loading