Magellan MobileMapper Pro Guía De Inicio página 25

Selecting the
baud rate option
Note for users of the
post-processing option:
ALWAYS follow this
procedure to download
a job file whatever the
job mode –"real-time"
or "post-processing"–
you chose at the time
of job creation.
You will use the data cable almost all of the time so we'll start
there.
- MobileMapper Pro includes a data communication cable
that attaches to the 4-pin connector on the back of the
receiver (see opposite) and to the serial port on your PC.
Once you have attached the cable to the receiver and PC,
turn on the receiver and press ENTER three times until
you are on a navigation screen.
- Now launch MobileMapper Office. You can do this by dou-
ble-clicking on the icon on your desktop or by clicking on
the Windows Start button, browsing for the software in the
directory into which it was installed and double-clicking
on the name of the program.
On the menu bar at the top, click on File and then Down-
load from GPS. The MobileMapper Transfer window will
appear on the PC. On this window, click on File, then Con-
nect, then GPS Device via Cable. This will cause the transfer
utility to routinely test which baud rate should be used to
communicate with the receiver. Once communication is
established, the transfer utility starts reading the content
of the receiver's memory.
After a while, the window's left-hand pane should list the
content of the handheld's memory. Now browse for the
directory on your PC that you want to download the files
into. Then click on the job file (a .MMJ file) that you
recorded in the field (on the left side of the window) and
drag it into the PC directory (on the right side of the win-
dow). The job file you transferred over will be displayed on
the MobileMapper Office's Map Display area when you
close the MobileMapper Transfer window. You are then
ready to process your data.
19