Descargar Imprimir esta página

Argo MILO PLUS Manual De Instrucciones página 57

Ocultar thumbs Ver también para MILO PLUS:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 119
Analysis of common network setting errors:
If the short distance control does not work, perform the checks specified below:
• Make sure the air conditioner power is connected.
• Make sure that the air conditioner's WiFi function is normally active.
• Make sure your phone's WiFi selects the corresponding air conditioner.
• Reset with the remote control and restart the setting from step 3.
It is important to remember what is listed below.
1. The WiFi function of the air conditioner takes about 1 minute to start.
2. The air conditioner is equipped with memory function.
CARE AND MAINTENANCE
WARNING!
Prior to carrying out any cleaning or maintenance, unplug the unit from the power socket.
1. Cleaning the air filters
The air filter must be checked at least once every two weeks of operation. Operating with dirty or clogged filters will
decrease the effectiveness of the air conditioner and can cause serious problems.
To remove the filter, release the rear grille then slide out the filter by gently pulling it sideways.
Use a vacuum cleaner to remove any dust. Should
this not be sufficient, wash the filter with lukewarm
water and neutral detergent (if necessary), rinse it
with cold water then leave it to dry naturally before
putting it back in place. After putting the filter back
in place, close the grille and resume use of the air
conditioner.
2. Cleaning the casing.
Use a soft damp cloth to clean the outer surface of
the air conditioner.
Do not use excessively hot water, solvents, petrol
or other aggressive chemical compounds, talcum
powder and brushes: they may damage the surface
or colour of the casing.
Remove any stains using warm water with a little
neutral detergent.
V 11/19
57

Publicidad

loading