BH G825 Manual Del Usuario página 9

KEYPAD (Fig.3).
The function of each key is listed below. See Fig.3
The electronic monitor includes an easy-to-use keypad. This keypad consists of Fan keys ( E ), numeric
keys ( F ) and function keys ( G ).
- Fan keys (E) – Off / On.
- Numeric keys (F) - (1- 0) are used to enter the data requested by the monitor or select the default
program (1-8).
- Function keys (G) – reset; level▲; level▼; enter; pause; stop; quick / start. Are used to select a
particular exercise, enter requested data, control exercise exertion levels and to finish the exercise.
-reset.-
Reset key. This is used to erase the data that have been entered into the monitor when selecting
a program.
-level ▼
.- Key for decreasing exertion level. When pressed during exercise this key will decrease the
exertion level by one machine setting. During the selection of pre-programmed profiles, it is used to move on
to the next profile screen. During the introduction of user data is used to decrease the value.
-level ▲
.- Key for increasing exertion levels. When pressed during exercise this key will increase the
exertion level by one machine setting. During the selection of pre-programmed profiles, it is used to move
back to the previous profile screen. During the introduction of user data is used to increase the value.
-enter .-
Selection and validation key. This is used during pre-programmed profile selection to select a
profile, confirm data that have been entered.
-pause.-
Pause key. If this is pressed during a session, the exercise is interrupted and the exercise
chronometer is halted. To restart the exercise chronometer press the quick start key.
-stop.-
Stop key. If this is pressed during the session, the exercise will be taken as finished and exertion
settings will drop to minimum level. A summary of all the exercise data will be displayed.
-quick / start.-
Quick start key. When this key is pressed, provided that the LED on the key is flashing,
exercise will begin in manual mode. It also starts the selected program after entering the data.
OPERATING INSTRUCTIONS.-
STARTING THE FAN. -
The monitor on this machine is fitted with an air vent (D), Fig.1. To switch the fan on while exercising press the
ON/OFF key on the keypad, Fig.3, and the fan will start. Whenever the monitor is switched to main menu the
fan will switch off.
COOL DOWN
At the end of an exercise without pressing STOP key previously, the monitor enters COOL DOWN mode that
will be displayed in the lower alphanumeric display (B) for 5 seconds. This mode is used to reduce the intensity
of exercise and facilitates recovery. The level of braking can be adjusted using the ▲ / ▼.
Time will vary depending on the duration of the exercise:
TOTAL TIME
5 minutes
5 - 9:59 minutes
10-19:59 minutes
20-29:59 minutes
30-39:59 minutes
More than 40 minutes
This mode can not be interrupted. At the end of this time, the monitor will display your exercise data.
MANUAL MODE.-
Press the ▲/▼ keys to select the MANUAL function and press ENTER. Press START to begin exercise. If
you press the START key while at the start screen, exercise will begin directly in manual mode. En LED
matrix display top (A) Fig.2 will prompt flashing at the level that is performing the exercise.
.
COOL DOWN TIME
60 seconds
90 seconds
120 seconds
180 seconds
240 seconds
300 seconds
9
G825