HDMI HDBaseT + USB-B to A and RS232 over Cat Extender Single Gang Wall Plate
Transmitter to Box Receiver - 4K 60Hz
Product Overview
Front Panel
Transmitter
F
P
D
RONT
ANEL
ESCRIPTION
On: Power is applied to the device.
1
Power LED
Off: No power is applied to the device.
On: HDMI input signal is active.
2
HDMI LED
Off: No HDMI signal input.
On: HDBT link is normal.
3
LINK LED
Off/Blinking: No HDBT link or link error.
4
HDMI IN
Connect to an HDMI source using an HDMI cable.
5
USB HOST
Connect USB host PC.
Rear Panel
Transmitter
R
P
D
EAR
ANEL
6
HDBT OUT
Connect to the HDBT receiver via a Cat 5e/6/6a/7 cable.
Connect to a DC 12V power adapter. With one-way PoH
7
DC 12V
function supported, the transmitter can be powered by the
receiver.
Connect to a RS232 enabled device for RS232 pass-
8
RS232
through or firmware upgrade.
Set the function of RS232 port.
PASS THROUGH: RS232 port is used to command pass-
through via HDBT. Users can use API command to
RS232 DIP Switch
9
upgrade transmitter's MCU firmware in this mode.
UPDATE: RS232 port is used to update Valens firmware of
transmitter and receiver.
2
ESCRIPTION
(us)