Publicidad
Idiomas disponibles
Idiomas disponibles
HDMI HDBaseT + USB-B to A and RS232 over Cat Extender Single Gang Wall Plate
Transmitter to Box Receiver - 4K 60Hz
Product Overview
Front Panel
① ② ③ ④
F
P
D
RONT
ANEL
ESCRIPTION
On: Power is applied to the device.
1
POWER LED
Off: No power is applied to the device.
Blinking: The device is working properly.
2
STATUS LED
Off: The device is not working properly.
On: HDCP protected content is being transmitted.
3
HDCP LED
Blinking: Non-HDCP protected content is being transmitted.
Off: No content is being transmitted.
On: HDBT link is normal.
4
LINK LED
Off/Blinking: No HDBT link or link error.
Set the function of RS232 port.
Pass-through (Default): RS232 port is used to pass RS232
RS232 DIP
commands over HDBT.
5
Switch
MCU: RS232 port is used to update receiver's MCU firmware.
VS: RS232 port is used to update Valens firmware of transmitter
and receiver.
Receiver
⑤
Rear Panel
⑥
⑦
R
P
D
EAR
ANEL
ESCRIPTION
Connect to a DC 12V power adapter. With one-way PoH function
6
DC 12V
supported, the transmitter can be powered by the receiver.
7
HDBaseT IN
Connect to HDBT OUT of the transmitter via a Cat 5e/6/6a/7 cable.
8
RS232
For RS232 pass-through or firmware upgrade.
9
HDMI OUT
Connect to an HDMI display device.
Unbalanced stereo audio output.
10
AUDIO OUT
PASS-THROUGH: Reserved.
DE-EMBED: For audio de-embedding from the HDMI output.
Connect to USB devices such as keyboard, mouse, USB camera, etc.
4x USB
Note: USB ports support USB 2.0 standards with a maximum of 1.4A
11
DEVICE
for the top two ports and 0.6A on the bottom two ports. USB cameras
are recommended to be connected into one of the top two 1.4A ports.
3
Receiver
⑨
⑩
⑪
⑧
(us)
Publicidad
