HDMI HDBaseT + USB-B to A and RS232 over Cat Extender Single Gang Wall Plate
Transmitter to Box Receiver - 4K 60Hz
Features
HDMI 1.4 with 4K at 60Hz, 4:2:0, 8bit and HDCP 2.2 compliant
•
Supports signal transmission up to 35m/115ft for 4K and 60m/197ft for 1080P via a single
•
Cat 5e/6 cable
Supports signal transmission up to 40m/131ft for 4K and 70m/230ft for 1080P via a single
•
Cat 6a/7 cable
Supports one-way PoH, the transmitter can be powered by the receiver
•
Supports USB pass-through and RS232 pass-through via HDBT port
•
Provides high power USB device ports, supporting higher power for connected USB devices
•
Supports firmware upgrade through RS232 port, and can be set through the DIP switch
•
Mounting Bracket Installation
Note:
Before installation, please ensure the unit is disconnected from the power source.
•
The height of installation should not exceed 2 meters from the ground.
•
Installation steps:
1. Attach the installation bracket to the enclosure using the screws that were provided
in the package separately.
2. The bracket is attached to the enclosure as shown.
3. Repeat steps 1-2 for the other side of the unit.
4. Attach the brackets to the surface you want to mount to using screws (not included).
4
Package Contents
1 x Transmitter
•
1 x Receiver
•
1 x DC 12V US Power Adapter
•
1 x Phoenix Connector (3.5mm, 2 Pins)
•
2 x Phoenix Connector (3.5mm, 3 Pins)
•
1 x 1 – Gang US Socket Cover, White
•
(with Screws)
2 x Mounting Brackets (with screws)
•
1 x Manual
•
(us)