Publicidad
Idiomas disponibles
Idiomas disponibles
HDMI HDBaseT + USB-B to A and RS232 over Cat Extender Single Gang Wall Plate
(us)
Transmitter to Box Receiver - 4K 60Hz
RS232 Pass-Through
RS232 default setting areas are as follows:
RS232 ports can be used for bi-directional RS232 signal pass-through between the transmitter
and receiver. Set both DIP switches of the transmitter and receiver to the position of PASS-
THROUGH. Connect RS232 enabled devices (such as PC) to RS232 ports of the transmitter and
receiver. API commands can be sent to the transmitter from transmitter side or receiver side.
Before executing the API commands through RS232, please ensure RS232 interface of the device
and the connected PC are configured correctly.
Note: In Pass-through mode, API commands can also be sent to the transmitter from transmitter side or receiver side to change baud
rate, get its firmware version or upgrade its MCU, etc.
Pins and wiring figures are as follows:
6
Publicidad
