Ordering Information - Heathrow Scientific Gusto Manual De Instrucciones

1.5mL / 2.0 mL Circular Rotor
2 Tubes 3 Tubes
0.2mL Tube Rotor
2 Strip
2 Strip 2 Tubes
Tubes
10 Tubes
Warning!
Do not attempt to open lid until rotor has completely stopped!
Avoid severe personal injury or property damage from moving parts.
Only use rotor compatible with the centrifuge.
Rotor installation and removal
To remove rotor:
— With one hand, grasp the rotor. With the other hand, unscrew
center knob counter clockwise until it disengages from the motor
shaft.
— Pull up on the center knob firmly. The rotor should easily lift off of
the motor drive.
To install the rotor:
— Check to make sure the bands on the rotor are in the slots.
— Set rotor onto the motor drive and push down until seated.
— With one hand, grasp the rotor. With the other hand, screw the
center knob clockwise until it engages the motor shaft.
Keep turning the knob until it tightens.
— Do not over tighten the knob.
Warning!
Do not use damaged or cracked rotors!
10
4 Tubes 6 Tubes
4 Tubes 6 Tubes
12 Tubes
Maintenance
8 Tubes
Your mini-centrifuge is normally maintenance-free. Clean unit
only when it is not plugged into an electrical outlet. When
necessary, the housing and rotor can be wiped using a damp
cloth and a mild, non-corrosive detergent.
Warning!
Do not use any solvent on the unit that may attack plastic
8 Tubes
or cause cracks in the rotor. Ensure the rotor is protected
from corrosion and mechanical damage. The rotor must be
cleaned with a neutral cleaning liquid.
If hasardous sample is spilled on the unit and or leaked
into the unit, do not run the centrifuge unless it is safe to
do so.
Dissassembly of Rotors for Cleaning
1. Remove rotor from unit
2. Remove screws from the bottom of the rotor
3. Clean as needed
4. Reasssemble rotor, making sure that the alignment tab is
engaged into the slot.
5. Test run reassembled EMPTY rotor to ensure it is still
balanced
Notes
—Ensure all parts are throughly dry prior to operation.

Ordering Information

Mini-centrifuge with AC adapter, 2 rotors,
rotor cover, and tube adapters ........................................ HS10050
Standard Rotor................................................................HS100503
Strip Tube Rotor..............................................................HS100504
Rotor Knob......................................................................HS100505
Standard Rotor Cover.....................................................HS100506
11