Hella Dyna View Instrucciones De Montaje página 10

Tools required:
• Drill with 3 mm dia. and 5.5 mm
dia. bits
Function description:
Cornering
lights
Right
Electrical Connection
10
Page 3:
Plug connector to driving lamps:
Blue hot-shrink tubing = right lamp
Black hot-shrink tubing = left lamp
Wire colours:
Red
Blue
Yellow/grey
• Combination pliers
• 17 mm open end or box wrench
• 6 mm Allen wrench
The driving lights can be switched
on together with the main beam
headlamps.The cornering lights are
switched on automatically by the
electronic control when cornering
and switched off again after exiting
the corner.
Left
Park unloaded vehicle on a level
surface.
• Disconnect ground lead from
battery
• Find installation location for
Right
control module where it is
protected from splashing water
Left
• Plug connections should point
downwards
• Align control module with bubble
level in the vertical and horizontal
directions, Maximum permissible
deviation ±10° (see Fig. A,
Page 5)
• Fasten with self-tapping sheet
Green metal screws or metric screws
• Seal drilled metal parts with rust
Ignition
protection agent
• Bubble level
• Ruler
The cornering light function is
always available when the main
beams are switched on.
Route connection line supplied
cleanly in accordance with circuit
diagram and secure with cable
straps.
When wired as shown in circuit
diagram I , the driving lamps are
switched on together with the
present main beam headlamps.
If wired as shown in circuit diagram
II , the driving lamps are switched
on in addition to the present main
beam headlamps with a separate
switch.