TRAPP TRF 50 Manual De Instrucciones página 42

Assembly of TRF 400F; TRF 80F; TRF 70
and TRF 50
Some of this equipment's components come
disassembled from the factory, to assemble, follow
the following instructions:
Assemble the trestle and the body
To begin assembling, remove the two sides of the

rack (1) from their packaging and assemble with the
crossbar (2), the screw (3), the washer (4) and the nut
(5) that are in the manual. Repeat the operation on
both sides.
Electric
Some TRAPP shredders, whether single- or three

phase, are provided with dual voltage motors,
and come out from the factory without electric
connection, so that the customer may select the
connection type, according to voltage provided in
the local power grid.
All the TRAPP shredders, with gasoline-powered

engine, come out from factory mounted without oil
in the engine and without gasoline, before turning
the engine on, the following information must be
verified and followed, according to page 34.
Some models of shredders are provided with a 127

and 220 V voltage selector. Check if the voltage
indicated in the selector is compatible with the
power grid voltage before plugging the engine in, if
necessary adjust the voltage as indicated on page 49
of this manual.
In order to perform the correct connection, the data

indicated in the motor's identification plate and the
numbering printed in the power cord insulation
itself, when the shredder is provided with an electric
motor.
Some models of shredders are provided with an IP22

motor mounted uncovered in the shredder's frame;
to connect the wires, check the motor's identification
plate and proceed with the connection in the on/off
switch wire.
The other electric models are provided with an

IP00 motor and are housed in a plastic protection;
to proceed with the wires connection according to
the local power grid, remove the plastic protection
as indicated on page 49 to have access to the motor,
the motor connection plate and the connecting
42
Then align the sides of the rack and the crossbar on

a flat base and tighten the screws using the wrench
provided in the manual.
After you finish tightening them, assemble the body

(6) on the rack, aligning the holes and affixing the
screw (7), the washer (8), and the nut (9), and tighten
the screws using the wrench provided in the manual.
Note: Some models have a switch assembled on the
rack, in this case use the self-tapping screw to affix the
On/Off switch in the position indicated by the arrow.
Motor Installation
wires; after completing the wire connection, close
the protection again.
For shredders traded without motor, the minimum

power choice must follow the technical data
presented on page 33.
Note:

Before making any connections, make sure
power source is disconnected.
1. Make sure the power source where the
2. Disconnect the power source to make motor
3. Make the connections shown according to
4. Make sure the connections are well
5. After connecting the motor wires to the
It is recommended that the connection
of the electric motors is conducted by a
professional electrician.
Attention!
shredder will be installed is compatible with
the data shown on the motor plate.
connections.
the voltage of the power source.
insulated.
on/off switch, connect the motor to the
power grid and verify the motor rotation
direction, if necessary, change the motor
wire connection as indicated in the motor to
reverse the rotation.
www.trapp.com.br