TRAPP TRF 50 Manual De Instrucciones página 50

Rubber Pad TRF 300; TRF 90 and TRF 80G
In order to attach the rubber pad, proceed according

to the figure beside. Mount the rubber pad in the
frame base, by using a flat, lock washer and a nut.
Maintenance is critical to prolong the life and
performance of any agricultural implement.
Good maintenance of the machine ensures good
performance, long life of your equipment and
increase work safety.
The operation times reported in this manual are
for informational purposes only and are referenced
under normal use and therefore may vary by type of
service, environment, seasonal factors, etc.
General maintenance
For every 10 hours of work
At the end of every working day, it is recommended

to clean the machine so that its part remains in good
operating conditions.
Make an overall inspection for loose or damaged

parts.
Make sure the blades are in good condition, sharp

and perfectly still.
For every 50 hours of work
Make sure the belts are properly tensioned.

Make sure all nuts and bolts are tight.

Counter cutting blade
Periodic tightening of screws as well as the
adjustment of the counter cutting blades are
essential.
The adjustment is done by loosening the hexagon
nut (1) as in figure 7 and by displacing the counter
cutting blade until the cutting blades pass at a
distance of approximately 2.0 mm from the counter
cutting blade for the shredder TRF 80G (figure 8)
and 1.5 mm from the counter cutting blade for the
other shredders shredders (figure 9).
50
Maintenance Instructions
12
Rubber pad
The counter cutting blade must be replaced
whenever it show wear signs or cracks, it is also
possible to reverse its side and sharpen it following
he same angle.
Use a ruler with the same measurement to obtain
the approximate distance between the cutting
blade and the counter cutting blade and use this as
a template, if necessary, or use another appropriate
measuring tool.
1
FIg. 7
2,0
2,0
Fig. 8
www.trapp.com.br
12
Merely illustrative image