APRILIA eSR2 Manual Del Usuario página 17

Brake adjustment
eSR2 / eSR2 EVO / Tuareg
If the brake is too tight or too loose, adjust it by loosening
or tightening the screw (A).
If the brake lever is too soft or too hard even after following
the instructions in the first step, it may be necessary to
repeat the operation until the optimal setting has been
reached.
eSRZ
If the brake is too tight or too loose, use the Allen wrench to
loosen the screw (A), then adjust the brake cable, (shorten
the brake cable at the top if it is too tight; if it is too loose,
pull the brake cable downwards) and then, re-tighten the
screw (A).
Check the correct alignment between the brake caliper and
the disc. Use the screws (B) and (C) to adjust the position /
alignment on the disc, if necessary.
16