Denon AVR-X1200W Manual Del Usuario página 60

Contents Connections
Wireless LAN
When connecting to a wireless LAN network, stand the rod antenna for
Bluetooth/wireless LAN connection upright on the rear panel.
See "Wi-Fi Setup" on how to connect to a wireless LAN router.
(v p. 198)
Internet
Router with access
point
Front panel Display
Playback
Modem
To WAN side
60
Rear panel
Settings
0 When using this unit, we recommend you use a router equipped with the following
functions:
0 Built-in DHCP server
This function automatically assigns IP addresses on the LAN.
0 Built-in 100BASE-TX switch
When connecting multiple devices, we recommend a switching hub with a
speed of 100 Mbps or greater.
0 Only use a shielded STP or ScTP LAN cable (readily available at electronics
stores). (CAT-5 or greater recommended)
0 The normal shielded-type LAN cable is recommended.
If a flat-type cable or unshielded-type cable is used, other devices could be
affected by noise.
0 When using a router that supports the WPS （Wi-Fi Protected Setup） function, Wi-
Fi connection can be carried out easily.
0 When using this unit connected to a network with no DHCP function, configure the
IP address, etc. in "Network". (v p. 197)
NOTE
0 The types of routers that can be used depend on the ISP. Contact your ISP or a
computer shop for details.
0 This unit is not compatible with PPPoE. A PPPoE compatible router is required if
your contracted line is not set using PPPoE.
0 Do not connect a NETWORK connector directly to the LAN port / Ethernet
connector on your computer.
0 Various online services may be discontinued without prior notice.
Remote
Tips Appendix
Index