Publicidad
Idiomas disponibles
Idiomas disponibles
We value your experience using Sunny Health and Fitness products. For assistance with parts or
troubleshooting, please contact us at support@sunnyhealthfitness.com or 1-877-90SUNNY (877-
907-8669).
ASSEMBLY INSTRUCTIONS
A
STEP 1:
Attach the Front & Rear Stabilizers (No. 3
& 4) to the Main Frame (No. 1) with 4
Carriage
Bolts
Washers (No. 52), 4 Arc Washers (No. 13)
and 4 Acorn Nuts (No. 14). Tighten and
secure with Spanner (No. 99).
STEP 2:
Check the Tension Controller (No. 17) is
at the
lowest level
longest. Connect Extension Wire (No. 18)
to Sensor Wire (No. 20) then connect the
cable of Tension Controller (No. 17) to
the hook of the Tension Cable (No. 19) as
shown in Figure A.
1. Insert eye of upper tension cable into the
cable lock.
2. Pull the tension cable so that you can
insert the cable into the gap at the top of the
metal bracket.
3. Lower the tension cable so that it sits on
the metal bracket.
Remove pre-assembled 6 Inner Hex Bolts
(No. 16), 6 Spring Washers (No. 52) and 6
Arc Washers (No. 13) from Main Frame
(No. 1), then attach the Handlebar Post
(No. 2) to the Main Frame (No. 1) with 6
Inner Hex Bolts (No. 16), 6 Spring
Washers (No. 52) and 6 Arc Washers (No.
13) that were removed. Tighten and secure
with Wrench (No. 100).
NOTE:
Do not completely tighten the bolts
yet.
9
(No.
12),
Spring
4
to ensure the cable is the
Publicidad
