Publicidad
Idiomas disponibles
Idiomas disponibles
1. If you find there is no difference between tension level 1 to level 8, check the connection of the
tension cable. See Diagram below.
2. If the computer does not show numbers correctly, check the batteries. If the computer does not
count the speed and time, check the connections of Extension Wire (No. 18) to the Computer
(No. 9) and Extension Wire (No. 18) to Sensor Wire (No. 20).
3. If you have difficulty putting Hinge Bolts (No. 38L/R) into the Crank (No. 22), try moving the
Crank (No. 22) to a different angle. Keep in mind the Left Hinge Bolt (No. 38L) has reverse
threading and must be installed by turning counter-clockwise.
4. If you hear any noise when using the machine, please check if Hinge Bolts (No. 38L/R), Hex
Bolts (No. 30), Hex Bolts (No. 24) and Connecting Joints (No. 40L/R) are loose. You may
remove these parts and add some lubricant oil to eliminate all noise possibilities, remember to
tighten all the parts securely.
5. When you first use the machine, if you hear any unusual noises from the inside of the Belt
Cover (No. 66L/R), please loosen the screws on the chain cover about two rotations, then
push the Belt Cover (No. 66L/R) up a little bit; finally, fasten the screws you loosened before.
See the following diagram. (During shipping, the Belt Cover (No. 66L/R) can be dislocated,
and the Flywheel (No. 96) may rub on the Belt Cover (No. 66L/R).
ADJUSTMENTS & USAGE GUIDE
13
Publicidad
