FAR KJ 60 Instrucciones De Uso página 13

KJ 60
GB
PLACING OF THE INSERT
Make sure that the couple tie-rod/head mounted on your riveting tool is suitable for the insert to clamp; otherwise, change size
accordingly. Usually the riveting tool is supplied with the couple tie-rod/head corresponding to a M8 thread. Before using the
riveting tool and after any change of size, perform the following operations according to the size and thickness of the part to
clamp. Adjust the riveting tool stroke to the minimum by turning the ring nut "G" to "–" marked on the tool. Place the insert on
the tie rod and push slightly on it so as to make it clamp automatically. Make sure the insert head touches the riveting tool head
properly. Fasten the insert and in order to ensure a proper clamping of the material, adjust the riveting tool stroke by turning the
ring nut "G" accordingly. By increasing stroke, i.e. by turning the ring nut "G" to "+", the distance "h" between head and insert
deformation will decrease and clamping will result more effective.
WARNING!!!
A wrong adjustment of the riveting tool stroke may cause a faulty clamping of inserts and may brake the tie rod!
G
+
–
750313 - KJ60 – rev 24 - ( 09-2022) 13