Infinite spa CHAMPION Manual De Instrucciones página 60

5
Troubleshooting
ERROR MESSAGES
The following error codes may be shown on the display:
Error code
SL
SH
HL
FH
(with warning sound)
OC
IMPORTANT INFORMATION ON PROBLEMS
A. Loss of air
Inflatable spas, by design, may lose air after a period of time, especially when exposed to cold temperatures.
This is a normal phenomenon and does not mean that the spa has a defective area where air is leaking.
Step 1
Check the tightness of the air valve screw connection (black/grey). This valve has a double function, i.e. to inflate and deflate air..
Note: After inflating the SPA, it is possible that the lower screw connection has loosened during the inflation process. After inflation, the follo-
wing must therefore be done to prevent air leaks:
Air inlet (black):
Air outlet (grey):
Step 2
If air continues to leak after step 1, perform the following test to locate the affected area:
- Spray soapy water on the
PVC body of the spa.
Manual SPA 2/4/6/8 2021 print NEU 18/11/21.indd 60 Manual SPA 2/4/6/8 2021 print NEU 18/11/21.indd 60
Cause
The water temperature is 5° C or less
Malfunction of the circuit board or the temperature
sensor.
Malfunction of the filter pump
The temperature of the temperature sensor is too high
The filtration and heating have been in operation for
72 hrs. Before replacing the filter cartridge, neither
the filtration pump nor the heater are ready for
operation.
Malfunction of the temperature sensor
screw the screw cap back on hand-tight
tighten the lower part of the screw connection hand-tight
Solution
Wait until the water temperature is >5° C.
Perform a reset (in accordance with point 2 - Installation).
Replace the display and/or the motor block.
Check the water level in accordance with point 2 - Installation)
Perform a reset (in accordance with point 2 - Installation)
Wait until the ambient temperature has dropped. As soon as the sensor detects
<45° C, the spa is ready for operation.
Replace the filter cartridge and press the HEATER button to restart the
filtration and heater.
Perform a reset (in accordance with point 2 - Installation)
Replace the motor block
- Bubbles will form on the
leaky area
23.11.21 18:10 23.11.21 18:10