Infinite spa CHAMPION Manual De Instrucciones página 62

5
Troubleshooting
6. When the pre-set temperature is reached, the heating element switches off while the red LED for the heater (HEATER) remains illuminated.
The filter pump does not switch off automatically. If the water temperature drops below the pre-set temperature, the heating system starts to
work again. If the heating system is not to restart automatically, both the heating system and the filter pump must be
switched off by pressing the HEATER and FILTER buttons.
Note: The integrated temperature sensor works with an accuracy of +/- 2°C. Depending on the set water temperature, it may therefore be the
case that the heater / pump does not switch on immediately but with a delay. This is not a malfunction.
Note: In cold weather, it takes between 12 and 24 hours to heat the water to the desired temperature. The ambient temperature and the tempe-
rature of the mains water affect how long it takes for the water to heat up. The water temperature drops every time the heater is switched off on
the SPA. Wait until the water has heated up before using the SPA again.
3. The ambient temperature is too low
If the ambient temperature is below 10 ° C, the heater works slower than normal.
Note: It is advisable to use the SPA indoors in low ambient temperatures.
4. Winter mode
All SPA functions are blocked at am ambient temperature below 0°C. Operating the heating system or other functions at sub-zero temperatures
can cause irreversible damage to water pipes and electrical components inside the motor block.
E. LEAKAGE DUE TO A CRACK/HOLE
To repair minor cracks or leaks on the inside or outside of your spa, you will find a repair kit included.
This consists of a white patch for the inside of your spa and a patch matching the corresponding colour of the outside.
To repair the damaged area, we recommend that you use a 2-component adhesive, which is not included in the scope of delivery.
After you have repaired the leakage area in accordance with A. AIR LEAK - step 2 and have a suitable adhesive available, proceed as follows:
1. Remove the water from the spa.
2. Release the air from the spa.
3. Fit the patch to the damaged area by allowing the patch to extend about 3-4 cm in all directions beyond the damaged area and cut
it accordingly.
4. Place the patch over the damaged area and mark all 4 corners, or a circular shape of the patch on the spa.
5. Make sure the area to be patched is free of dirt and moisture.
6. Apply tape or electrical tape outside the marked area in order to concentrate the adhesive on the location of the patch.
Make sure that the area to be patched is 0.3 - 0.5 cm larger than the damaged area actually is.
7. Now apply the adhesive according to the manufacturer's instructions.
8. Apply the patch.
9. Allow the adhesive to dry according to the manufacturer's instructions.
10. Inflate the spa according to the installation instructions.
11. Observe the patch over a period of 24 hours to see if the leak has been repaired.
12. If air is no longer leaking, proceed in accordance with the installation instructions.
F. DEFORMATION
Make sure that you install the spa properly according to instructions in 2. 1 .
Spas installed outdoors may inflate due to partial or full solar radiation and cause irreversible deformation.
Make sure that the spa tub is not exposed to direct sunlight in outdoor areas.
Manual SPA 2/4/6/8 2021 print NEU 18/11/21.indd 62 Manual SPA 2/4/6/8 2021 print NEU 18/11/21.indd 62 23.11.21 18:10 23.11.21 18:10