HOLZMANN MASCHINEN STM26 Instrucciones De Servicio página 37

CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
 Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
16.1 Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
Remove chips and dirt particles from the machine after each use with a proper tool.
•
Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
•
(e.g. WD40 rust inhibitor).
16.2 Maintenance
The machine is low-maintenance and only a few parts need to be serviced. Malfunctions or defects
that could affect your safety must be repaired immediately!
Before each operation, check the perfect condition of the safety devices.
•
Regularly check the perfect and legible condition of the warning and safety labels of the
•
machine.
Use only proper and suitable tools.
•
Use only original spare parts recommended by the manufacturer.
•
Maintenance plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the technical limits:
Interval
Before usage
Cable and plug
Screw connections
Once a week
Moving parts
Guideways
Worktable guideways adjustment
HOLZMANN Maschinen GmbH
WARNING
Components
www.holzmann-maschinen.at
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
NOTE
Check for damage and replace if
Check for tightness
Lubricate
Lubricate
1.
2.
3.
4.
5.
Action
necessary
Remove all dirt from the area.
Loosen the nuts.
Adjust the guideways with
the worm screws.
Tighten the nuts again.
Check the smooth
movement and adjust the
settings if necessary.
37
STM26 | STM26S