Descargar Imprimir esta página

Silhouette DWC276BLS Manual Del Usuario página 10

Publicidad

Installation Instructions - Intergrated Application
Tools You Will
Need
Safety Glasses
FOR YOUR SAFETY:
While performing
installations described in
this section, gloves, safety
glasses or goggles should
be worn.
Drill & Hole Saw set
Preparing the
Important: It is recommended
that you install the wine cooler in
Enclosure
a location that allows the door(s)
to have a greater then 45° open-
ing swing. A limited door swing
will prevent the shelves from
Electrical Requirements:
sliding out as intended, and may
lead to damaging the door gas-
The appliance must be
ket(s).
connected to an individual
properly grounded electrical
• The rough cabinet opening
outlet, protected by a 15 or
must be on a level floor area
20 ampere circuit breaker or
and at least 24" deep* by 12-1/2"
time delay fuse.
wide. The opening should also
have a height of at least 34-1/2".
Fig C
34-½" From
Underside of
Countertop to
Floor
*The listed depth requirment for the installation is assuming that the electrical outlet is located in the adja-
cent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.
All manuals and user guides at all-guides.com
Level
Philips
Gloves
Screwdriver
Flashlight
Carpenter's
Square
Measuring
Tape
• The electrical outlet may be
positioned from within either
side of the adjacent cabinetry, or
the rear of the shaded area (as
shown in Fig C.).
Note: If the electrical outlet is
surface mounted (not flush) within
the enclosure, the depth
requirment for the installation be
affected.
• If the electrical outlet is located
inside the adjacent cabinetry, cut
a 1-1/2" diameter hole to admit
the power cord.
1-½" dia. hole
*If electrical
outlet is in
adjacent
*
cabinetry
2"
Electrical Access
6"
12-½"
8
Instrucciones de Operación
Características de su
Heladera para Vinos
2
3
6
1. Puerta de Vidrio Templado:
Permite
ver fácilmente el interior. Polarizadas para
proteger contra la radiación UV.
2. Controles Electrónicos:
Para regu-
lar la temperatura de la heladera para vinos.
3. Juntas Magnéticas de la Puesta:
Las juntas ajustadas mantienen todo el poder
de enfriamiento y los niveles de humedad.
4. Estantes con Terminación de
Madera:
Se deslizan hacia fuera para
facilitar el acceso al vino.
5. Trabas con llave a prueba de niños.
29
1
5
7
4
8
6. Escape Frontal:
Permite su insta-
lación empotrada.
7. Llave de Encendido para Luces
Interiores:
Para encender/apagar manual-
mente las luces interiores con las puertas
cerradas.
8. Patas Niveladoras
9. Luces Interiores (no se muestran):
Se encienden cuando se abre cualquiera de
la puerta.

Publicidad

loading