Publicidad
Idiomas disponibles
Idiomas disponibles
Parts
Adaptor Unit
(CZ-TACG1)
Screw for wall mounting
(M4 x 20 – 1 piece)
Screw for embedded installation
(M4 x 10 – 1 piece)
Mounting cord clamp
(1 piece)
Cable tie (1 piece)
Double-sided
adhesive tape
Wall plug
Adaptor Installation
CAUTION
Shut off the power supply when installing this adaptor.
1. Select a location to install the adaptor.
(Adaptor can be installed on the wall near the indoor unit or embedded into indoor unit.)
2. Arrange the cable.
Make sure wall is clean
and free from dirt.
Use double sided
adhesive tape for
attachment on the wall.
Screw (M4 x 20)
General illustration for installation use
- Handle the cable gently so that no excessive external force will act on the
connector in the adaptor.
Embedded Installation into indoor unit
Screw (M4 x 10)
Cord clamp
General illustration for installation use
- Install the adaptor into the indoor unit and guide the cable follow the tunnel or
ribs into the control board area, similar as shown in the diagram.
Use the cable tie (included in the package) to tie excessive cables
together when necessary.
3. Fix the cord clamp with a screw.
4. Connect the cable to the CN-CNT connector at the indoor unit.
Take note each indoor unit CN-CNT connector location might be different.
Please consult authorized dealer.
5
Installation on the wall
Cable tie
L
N
1
2
3
Cord
clamp
Only applicable for certain
models. Please consult
authorized dealer.
Keep the excessive cables
carefully into the space
beside the control board.
Adaptor
Adhesive
tape
Wall
Publicidad
