cecotec Cumbia POWER MATIC-CCINO CREMMA Manual De Instrucciones página 27

ENGLISH
Warning
- When preparation starts, the appliance may splash hot milk or emit steam.
- Place the milk-tank connector tube around the milk-tank cover after each use. Do not drop
it, as it may splash milk due to the pressure difference.
Hot water
Place a container under the spout.
1.
Press the hot-water button (25): it will light up to indicate that the function has been
2.
activated and the machine will dispense hot water from the milk spout. The indicator will
remain lit during the preparation process.
Turning off the coffee machine
To switch off the machine, press the On/Off button.
Auto-off
The appliance is equipped with an automatic shut-off system. Depending on the selected
mode, the appliance will have a different automatic switch-off time (see "Modes" section).
Adjusting the hot/foam coffee/water quantity
You can store the desired quantity of coffee, frothed milk, or hot water.
You should follow these steps while frothing milk, dispensing hot water, or preparing a mild
coffee, strong coffee, latte macchiato, or cappuccino:
While the machine is preparing coffee (either mild or strong) or dispensing frothed milk or
1.
hot water, press and hold the button of the selected option. The appliance will continue
dispensing the selected beverage.
When the beverage quantity corresponds to the desired quantity, release the button. The
2.
machine will beep twice, indicating that the beverage quantity has been saved.
For cappuccino and latte macchiato, you must carry out steps 1 and 2 for both milk and
3.
coffee.
Adjusting the grinding level
You can adjust the grinder's grinding level by turning the adjustment knob in the coffee-bean
tank.
While the grinder is running, you can turn the knob to change the setting. CAUTION: never
1.
change the grinder settings when the grinder is not in operation, as this may damage it.
The dots on the knob indicate the grinding level. Fig. 8
2.
Modes
The machine has 3 different modes: Default mode, ECO mode, and Quick mode. In ECO mode,
the appliance will save more energy. In Quick mode, the user can prepare coffee faster than in
default mode.
52
POWER MATIC-CCINO CREMMA
ECO mode
Light indicator No
Pre-infusion* Yes
Automatic shut-off time 10 min
Coffee/milk/hot-water Yes
quantity setting
*Please note:
The pre-infusion function hydrates the ground coffee in the machine with a small amount of
water before coffee is fully extracted. This expands the coffee to create a higher pressure in
the coffee machine, which helps with the extraction of all the oils and the full flavour of the
ground coffee.
When the coffee machine is in Standby mode, press and hold the On/Off button for 5
1.
seconds.
The control panel will display the following indications for the different modes:
2.
Hot-water button (25)
In ECO mode steady light
In Quick mode flashing
In Default mode flashing
Press the hot-water button (25) to enter ECO mode, the strong-coffee button (20) to enter
3.
Quick mode, and the mild-coffee button (21) to enter Default mode. The device will beep
twice to indicate that one of the above-mentioned modes has been selected. (Note: if
you press the button corresponding to the mode already selected, the machine will not
respond).
If you do not want to change the settings, press the On/Off button again or wait
4.
approximately 10 seconds for the device to return to Standby mode.
ENGLISH
Quick mode Default mode
Yes Yes
No Yes
30 min 20 min
Yes Yes
Strong-coffee button Mild-coffee button
(20) (21)
flashing flashing
steady light flashing
flashing steady light
POWER MATIC-CCINO CREMMA
53