Daewoo DCS6524 Manual Del Usuario página 9

EN
Shows the direction in which the chain brake is released, (arrow back, brake released)and engaged
(arrow forward, engaged).
Posición: right front of the engine.
3. GUIDE BAR AND CHAIN INSTALLATION
WARNING!
The chainsaw chain teeth are very sharp. Wear suitable gloves as a protective
measure.
Make sure the chain brake lever is rearward, unlocking the brake. Loosen the
side nut and, depending on the model, a second anchor at the rear of the plate,
which fix the side plate and chain brake, and remove the plate.
Install the attached tooth into the tool bag on the right front of the engine, with the
tips facing up.
Shim the chain onto the sprocket next to the guide bar set screw. Put the guide bar
in position by going through it with the screw and around it with the cutter chain.
Tensioning the guide bar a little by hand, present the chain brake side cover and adjusting
the tensioner nut, check that the large hole in the bar matches the tensioner.
(1)Orifice
(2) Tensioner
(3) Chain brake side cover
9