Tabla de contenido
Publicidad
Fault
The sweeper fails to pick up large particles
of dirt or leaves traces of dirt behind.
Sweeper leaves dust on fl oor or dust
comes out from side fl aps
Dust comes out of the vacuum fan
Sweeper throws dirt forwards
Rapid brush wear
Main brushes noise different or excessive.
The main brushes does not turn
Battery does not maintain its charge
Battery discharges quickly
1) Cleaning:
When cleaning and washing the machine, take care when using aggressive detergents, acids, etc.
Follow the instructions provided by the detergent producer, and wear protective clothing if appropriate (e.g. overalls, gloves, goggles, etc.
- see EEC directives on this subject).
2) Explosive atmosphere:
The machine is not constructed to work in environments where there is a risk that there might be explosive gases, dusts or vapours, and so
its use in an explosive atmosphere is FORBIDDEN.
3) Disposal of harmful substances:
Comply with the laws in force on waste disposal and treatment when disposing of the material collected, the machine fi lters and spend
material such as batteries, motor oil, etc.
The machine should be consigned to an authorised disposal organisation, which will manage disposal correctly, especially with
regard to the oil and fl uids, fi lters, and batteries. ABS and metal parts should be recycled as secondary raw materials. Rubber hoses and
gaskets, and ordinary plastic and fi breglass, must be separated and consigned to municipal waste companies.
The packing of the machine is manufactured by recycling materials. Consign the spent materials to operators authorized to dispose.
44
TROUBLESHOOTING
Cause
Excessive working speed
Brushes pressure too light
Brushes worn
Bristles bent, or string or wire, etc.,
entangled in brushes
Filter clogged
Flaps worn out or broken
Filter torn
Front fl ap broken
Excessive brush pressure
Material wound around brushes
Transmission belts broken
Motor over-loaded
Battery terminals loose
Material entangled in main brushes.
Bearings seized
Excessive brush pressure
Battery cell burned out
Electrolyte level low
Insuffi cient charge time
Battery terminals loose or oxidized
SAFETY INFORMATION
SCRAPPING THE MACHINE
Corrective action
Decrease working speed
Adjust brush pressure
Lower or replace brushes
Remove string or wire and straighten
bristles in warm water
Clean fi lter
Replace fl aps
Replace fi lter
Replace fl ap
Reduce brush pressure
Remove entangled material
Replace belts
Check motor current absorption
Check or tighten battery terminals
Remove entangled material
Replace bearings
Reduce brush pressure
Replace battery
Top up electrolyte level
Increase charge time
Clean terminals and tighten
Publicidad
Tabla de contenido
