HEBU medical HBS 300i x-touch Instrucciones Para El Uso página 33

HBS 300i x-touch
2. Introduction
Our products are exclusively intended for professional use by appropriately trained and qualified
personnel and may only be acquired by them.
An electrosurgical unit is a generator used to transform electronic energy into high-frequency
alternating current (HF current).
If this current flows through human tissue, it creates heat which is used for cutting and for coagulation
of the tissue.
The HBS 300i x-touch is a versatile and compact electrosurgical unit which complies with a high
safety standard and unites economy with operative flexibility.
It offers the following application modes:
For monopolar surgical use
•
Pure cut
•
Blend cut
•
Polypectomy mode
•
Cutting in water environment (TUR)
•
Soft coagulation
•
Forced coagulation
•
Spray coagulation
•
Coagulation in water environment (TUR)
For bipolar use:
•
Blend cut
•
Cutting in water environment (TUR)
•
Coagulation (Mode "Bipolar Forceps")
•
Coagulation in water environment (TUR)
•
Bipolar coagulation (Mode "Bipolar Forceps" AUTO Start")
•
Vessel sealing, BiSeal®
Benefits of the HBS 300i x-touch:
◼
Simple, intuitive and safe operation
◼
USB-connection for service
◼
Current terminal for optional wireless foot switch, max. 0.5 A
◼
Display-supported neutral electrode safety system helps interactively when applying the neutral
electrode
◼
Nine storage locations for individual program settings
◼
Two monopolar multifunction terminals for 3-pin standard or Martin plug
◼
AutoStop function for automatic interruption of the energy supply after a certain vascular resistance
level is reached.
◼
Tone signal with scope for control of the volume, and an alarm tone in case of faults without facility
for switching off.
◼
Coloured illumination of the LCD display in red, yellow, blue or green to indicate different operating
modes or error statuses
◼
Facility for tracing output and impedance at the LCD display in the patient circuit on activation
◼
Worldwide application possible through connection scope from 100 to 260 volts, 50 to 60 Hz
◼
A successful sealing is confirmed visually and acoustically
EN
33