Publicidad
Idiomas disponibles
Idiomas disponibles
If the product supplier has not provided clear instructions, using the
Press the
button to confirm.
To exit the menu press the
In this case, the electronic control unit will automatically seek the ideal temperature for the product in the tank.
Even if the machine is set to a TLI temperature of -8,5°C/16.7°F, this does not necessarily mean that the
product in the tank (see temperature on the TANK TEMPERAT. screen) will arrive at said temperature. As
the electronic module automatically searches for the ideal product temperature, the temperature
registered on the TANK TEMPERAT. display may be higher than that on the TLI screen; product
temperatures may vary according to the type of product used.
When the product is ready, you can see "READY TO SERVE" on the display. In this case, the speed of the augers decrease
to 30rpm (default); this may be adjusted by changing the submenu settings in the SERVICE section;
It may happen that during production of ice cream, with a temperature of product below -2,0°C/28.4°F, the machine is
switched off, acting on main switch, or stop the rotation of the augers, acting on the augers switch
press of one of the two buttons, main switch or augers switch
When this procedure is activated, the augers will remain in stop position until the "9" becomes "1". After this time
(countdown counter) the augers will return to work and the electronic board will set in the previous condition before of
the shutdown. During the countdown must not be pressed any key.
To avoid reset of the above mentioned "WAIT 9 MINUTES FOR AUGERS" function, it is important that the
machine is not switched 'on' or 'off' when the countdown function is active.
This procedure serves to protect the gears and augers from abnormal loads caused by some ice pieces at the
bottom of the stainless steel. The ice can cause noise deriving from the gears that skid until the complete
block of the augers. If the machine does not restart, call the service support.
In the event the product in the tank is ready, i.e. on "Soft Mode READY TO SERVE", the display may show the following
warning:
This procedure is active when there is a lack of product in the tank. In this case, the solenoid valve will not be fed for a
period of 5 minutes, to avoid the formation of ice on the bottom of the tank; after this time limit the procedure is
deactivated.
If this occurs re-fill the tank.
key.
SOFT MODE
READY TO SERVE
WAIT 9 MINUTES
FOR AUGER
LOW MIX
PLEASE REFILL
key to decrease the TLI values to -8,5°C/16.7°F.
, you can see on the display
- 28 -
. With the next
Publicidad
