Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLAGE INSTRUCTIONS
1. Fix the stirrup
to the wall.
2. Insert the crown
in the driving wheel
(fig.1).
3. Insert the pulley
on the pin of the motor
4. Insert the split pin
on the pin of the motor
5. Insert completely the motor in the roll-tube (fig.2).
6. Fix the roll-tube to the driving wheel with m 4 x10 screw
(fig.2).
DESCRIPTION
This opening system is made of a tubular motor with built-in
control unit with the following characteristics:
• It is provided with a 434.15 MHz super-heterodyne radio
receiver
• It is driven by means of DOTTO / MAMMOLO transmitters.
• It is possible to drive the rolling shutter also by mean of an
external push-button (type: Normally Open, each series
or model).
• The programming phase can be effected via radio or by
means of an external switch.
• Obstacle detection: if during the closing phase of the rolling
shutter an obstacle is detected, the device opens the rolling
shutter completely.
WORKING TIME OF MOTOR
The control unit stops the motor movement after 5 minutes: in
case of limit switches malfunction this "time out" avoids the
motor overheating.
FUNCTIONING WITH EXTERNAL WIRED
SWITCH
Pressing the external wired switch, the control unit has the
following functioning logic:
OPENS
STOPS
CLOSES
FUNCTIONING WITH TRANSMITTERS
At each push button pressure, the functioning logic is the
following.
CLOSES
STOPS
STOPS
OPENS
OPENS
TRANSMITTERS PROGRAMMING
Up to 30 different channel can be stored on each central unit.
To store the transmitters read carefully the paragraph
"PROGRAMMING OF THE FUNCTIONS BY MEANS OF A
TRANSMITTER OF THE DOTTO /MAMMOLO SERIES"
of the limit switch
(fig.1).
.
STOPS
OPENS ...
CLOSES
CLOSES
STOPS
OPENS
PROGRAMMING OF THE FUNCIONTS BY
MEANS OF TRANSMITTERS OF THE RANGE
DOTTO
Using a transmitter of the range DOTTO it is possible changing
the functions of the control unit controlling the tubular motor.
DOTTO is equipped with a 10 switches dip-switch thanks to
which it is possible to change the desired functions: set on ON
the switch corresponding to the function required and follow
carefully the dedicated procedure.
WARNING: all the other switches have to be set on OFF
DIP FUNCTION
1
NOT USED
2
Storage of transmitters
3
Deletion of all the stored transmitters
4
Programming of opening limit switch
Programming of closing limit switch
5
(closed louver blades)
Programming of opening position of adjustable louver
6
blades
7-8
NOT USED
9-10
14
Publicidad
