Publicidad
Idiomas disponibles
Idiomas disponibles
PROGRAMMING OF THE FUNCIONTS BY
MEANS OF TRANSMITTERS OF THE RANGE
MAMMOLO
Using a transmitter of the range MAMMOLO it is possible
changing the functions of the control unit controlling the tubular
motor.
QUICK transmitter recording
To store the first TX1 transmitter proceed as follows:
CAUTION: the first transmitter recorded determines the direction
of the motor's movement.
1. Power only the motor to be programmed
2. Press and hold down UP and DOWN until the motor starts to
move in a direction
3. Release the buttons: the motor will stop
4. Press UP or DOWN following the direction the rolling shutter
moved prior to stopping:
- if the rolling shutter was rising, press UP; direction
acquired: the UP button raises the rolling shutter, the
DOWN button lowers the rolling shutter
- if the rolling shutter was lowering, press DOWN; direction
acquired: the DOWN button lowers the rolling shutter, the
UP button raises the rolling shutter
5. End of programming
To add other remote controls, proceed as follows:
6. Press and hold down the UP and DOWN buttons of a remote
control that is already recorded until the motor starts to move
in a direction
7. Release the buttons: the motor will stop
8. Press the UP or DOWN button on the new remote control
CAUTION: If the sunshade has a casing, record the first remote
control by following the procedure "1. Record the transmitters
and select the sunshade mode"
UP
STOP
DOWN
17
ADVANCED programming
To perform ADVANCED programming it is necessary to remove
the cover plate of the remote control and carefully follow the
dedicated procedures for the various functions.
Each function can be selected by entering a code during the
programming procedure; following is a summary table of the
functions with their relative programming codes.
CODE
FUNCTION
A
B
C
12 11 11 NOT USED
12 11 12 Storage of the transmitters
12 11 13 Deletion of all the stored transmitters
12 11 14 Programming of opening limit switch
Programming of closing limit switch
12 11 15
(closed louver blades)
Programming of opening position of adjustable
12 11 16
louver blades
12 11 17 NOT USED
12 11 18 NOT USED
12 11 21 NOT USED
A: Code to activate programming
B: Indicates channel 1 of the remote control; for channel 2 the number
is 12, for channel 3 the number is 13, etc. up to channel 6
C: Code of the function to be programmed
The pictures that follow include references to the buttons and
the LEDs used during programming.
UP
STOP
DOWN
PROG
Publicidad
