Publicidad
Idiomas disponibles
Idiomas disponibles
Switch 2: Storage of transmitters
To store the first TX1 transmitter proceed as follows:
WARNING: the first transmitter stored fixes the direction of
motion of the motor.
1. Only feed power to the motor to be programmed
2. Set on ON the switch 2 of the transmitter.
3. DOTTO multichannel only: press several times the key SELC of
the transmitter TX1 until displayed the selected channel.
4. Press and keep pressed (for about 5 seconds) the key PROG of
the transmitter TX1 until the motor starts to move in one way.
5. Release the key PROG: the motor stops.
6. Press the keys UP or DOWN depending on the way of motion
of the rolling shutter before stopping:
- if the rolling shutter was going up, press the key UP;
direction acquired: the key UP moves the rolling shutter
UPWARDS, the key DOWN moves the rolling shutter
DOWNWARDS.
- if the rolling shutter was going down, press the key DOWN;
direction acquired: the key DOWN moves the rolling shutter
DOWNWARDS, the key UP moves the rolling shutter
UPWARDS.
7. Set the switch 1 to OFF.
Try to operate the rolling shutter and check that it works with
the logic above described. If the logic is reversed, it is necessary
to delete all the codes stored (read Switch 3) and start again the
above procedure.
To add another transmitter TX2 to the control unit it is necessary
to use a remote control previously stored (TX1) and proceed as
follows:
1. DOTTO multichannel only: press several times the key SELC of
the transmitter TX1 until displayed the channel stored
2. DOTTO multichannel only: press several times the key SELC of
the new transmitter TX2 until display the channel to be stored
3. Take the rolling shutter to half its way with TX1.
4. Set to ON the switch 1 of the transmitter TX1.
5. Press and keep pressed for about 5 seconds the key PROG of
the TX1 until the motor starts to move.
6. Release the key PROG, the motor stops.
7. Press the key UP or DOWN of the TX2: the transmitter is
stored with the same logic of the TX1.
8. Set the switch 2 to OFF.
Switch 3: deletion of all the stored
transmitters
To delete all the transmitters stored on the control unit it is
necessary using a remote control previously stored and proceed
as follows:
1. Only feed the motor you want to use for the
cancellation
2. DOTTO multichannel only: press several times the button SELC
on the transmitter until displayed the channel stored.
3. Position the rolling shutter at the mid-height.
4. Set on ON the switch 3 of the transmitter.
5. Press and keep pressed the button PROG of the transmitter
until the motor moves in both the ways for 1 second,
showing the end of deletion.
6. Release the button PROG and set on OFF the switch 3 of the
transmitter.
To delete all the codes by means of a transmitter non-stored,
proceed as follows:
1. Position the rolling shutter at the mid-height.
2. Remove power from the system
3. Set on ON the switch 3 of a transmitter.
4. Press and keep pressed the button PROG.
5. Only feed the motor you want to use for the cancellation:
after about 1 second the motor moves in both the ways
showing the correct deletion.
6. Release the button PROG and set on OFF the switch 3.
15
Publicidad
