Publicidad
Idiomas disponibles
Idiomas disponibles
Storage of the transmitters
To store the first TX1 transmitter proceed as follows:
WARNING: the first transmitter stored fixes the direction of
motion of the motor.
1. Power only the motor to be programmed
2. Activate MAMMOLO programming by holding down buttons
4 and 6 until the 6 LEDs turn on
3. Release the buttons and enter the code 12 11 12
The two highlighted digits indicate the remote control channel
to be recorded; for channel 1 the digits are 11, for channel 2
the digits are 12, for channel 3 the digits are 13, etc up to
channel 6. Once the codes have been entered, the LED of the
selected channel will blink for 2 minutes after which it exits
programming.
4. Press and hold down the PROG button of the TX1 remote
control until the motor starts to move in a direction
5. Release the PROG button: the motor will stop
6. Press the keys UP or DOWN depending on the way of motion
of the rolling shutter before stopping:
- if the rolling shutter was going up, press the key UP;
direction acquired: the key UP moves the rolling shutter
UPWARDS, the key DOWN moves the rolling shutter
DOWNWARDS.
- if the rolling shutter was going down, press the key DOWN;
direction acquired: the key DOWN moves the rolling shutter
DOWNWARDS, the key UP moves the rolling shutter
UPWARDS.
7. To exit the programming mode, wait for the led to switch off
or press key 1 to exit immediately.
Try to operate the rolling shutter and check that it works with
the logic above described. If the logic is reversed, it is necessary
to delete all the codes stored (See procedure "3. Deleting all
recorded transmitters") and start again the above procedure.
To add other remote controls, follow points 6, 7, and 8 of the
"QUICK transmitter recording"
Deletion of all the stored transmitters
To delete all the transmitters stored on the control unit it is
necessary using a remote control previously stored and proceed
as follows:
1. Power only the motor you want to use for the
cancellation
2. Activate MAMMOLO programming by holding down buttons
4 and 6 until the 6 LEDs turn on
3. Release the buttons and enter the code 12 11 13
The two highlighted digits indicate the remote control channel
recorded in the control unit; for channel 1 the digits are 11,
for channel 2 the digits are 12, for channel 3 the digits are
13, etc up to channel 6. Once the codes have been entered,
the LED of the selected channel will blink for 2 minutes after
which it exits programming.
4. Position the rolling shutter at mid-height using
UP-STOP-DOWN
5. Press and hold down the PROG button of the remote control
until the motor starts to move in a direction
6. Release the PROG button: the motor will stop
7. To exit the programming mode, wait for the led to switch off
or press key 1 to exit immediately.
To delete all the codes by means of a transmitter non-stored,
proceed as follows:
1. Switch off power supply of the system.
2. Activate MAMMOLO programming by holding down buttons
4 and 6 until the 6 LEDs turn on
3. Release the buttons and enter the code 12 11 13
4. Press and keep pressed the button PROG
5. Power only the motor you want to use for the cancellation
6. Hold down the PROG button until the motor starts to move
for about 1/2 second in both directions, indicating that the
deletion has been completed.
7. Release the PROG button: the motor will stop
8. To exit the programming mode, wait for the led to switch off
or press key 1 to exit immediately.
18
Publicidad
