Setting The Filter - Keysight U1253B Guía Del Usuario Y Servicios

4 Changing the Default Settings

Setting the Filter

This setting is used to filter AC signals in the DC measuring path. The DC filter is
set to "ON" by default.
Table 4-3 Firmware version 2.25 or older
Parameter
FiLtEr
Table 4-4 Firmware version 2.26 or newer
Parameter
FiLtEr
Figure 4-32
– When the Filter is enabled, the measurement speed may decrease during DC
NOTE
– During AC or Hz measurement (on primary or secondary display), DC filter
144
Range
on or oFF
Range
on or oFF
Filter
voltage measurement.
will be automatically disabled.
Press Hz
to edit
Press
to switch between
OFF and ON
Press Hz to save
or press Esc
to exit without saving
Keysight U1253B User's and Service Guide
Default setting
oFF
Default setting
oN
or
and exit