SCOPREGA GE BTP Manual De Instrucciones página 4

Dear Customer, thank you for choosing GE BTP inflator. This unit has been designed specifically to
EN
inflate/deflate dinghies up to 5/6 metres and all kites on the market.
WARNINGS
- Before connecting the terminals to the battery, check that the voltage is the same as shown on the label.
- Keep the product out of the reach of children.
- Do not leave the inflator running unattended.
- Do not use the inflator with adapters other than those supplied with the product, as they could damage the
device.
- Repairs must only be undertaken by an authorised customer technical service Scoprega S.p.A.
- The manufacturer is not responsible for damage caused as a result of improper use or failure to observe the
envisaged usage.
ATTENTION: Long periods of use can cause overheating and damage the product.
Do not use for more than 20 minutes continuously.
INFLATION OPERATION
1 From the supplied fittings select the one that engages and opens the valve of the inflatable structure.
2 Insert the selected adaptor on the braided joint on the end of the hose.
3 Turn the ring nut on the manometer and point the arrow to the required pressure.
4 Tighten the adaptor onto the inflation side of the inflator (OUT).
5 Connect the terminals paying attention to the polarity and press the (ON) button to start inflation.
6 The inflator operates in two stages, which can be identified by the noise of the turbine at the beginning
followed by the piston. The inflator switches from turbine to piston automatically.
7 Once the entered pressure has been reached, the inflator turns off automatically.
It is possible to stop the inflator at any time by pressing the OFF switch.
ATTENTION: When the device is under pressure, never turn the ring nut on the manometer an-
ti-clockwise, as this would immediately cause the instrument to break. Protect the inflator from sand
by keeping it in the bag provided: if sand gets into the inflator, it could get JAMMED.
DEFLATING OPERATION
1/2 As above.
3 Tighten the adaptor on to the deflation side of the inflator (IN).
4 Connect the terminals and press the (ON) button to start deflation.
THE INFLATOR DOES NOT TURN OFF AUTOMATICALLY!!!
5
When the inflatable is completely deflated, switch OFF the inflator immediately to avoid overheating the
motor.
SAND FILTER MAINTENANCE
The inflator has a filter compartment under the inflation chuck (IN).
- We recommend to keep them clean for the inflator to be longer lasting
and more effective.
- Loosen the two screws blocking the inflation chuck (IN).
- Lift the chuck and take it off.
- Clean it with compressed air or replace it if it is too dirty.
BATTERY
A battery kit, including a Ni-Mh battery and a battery charger, is available and can be ordered to the retailer.