Descargar Imprimir esta página

Jump-N-Carry JNC122 Manual De Instrucciones página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

• The Jump-N-Carry provides plenty of power for starting vehicles – more than
enough to start most cars, light trucks, watercraft, implements and more.
• The Jump-N-Carry will power most 12 Vdc accessories equipped with a male
12 Volt plug. The DC outlet features automatic overload protection.
• The unit features a test switch and battery status gauge, which provides an
approximate indication of the battery's state of charge.
• The Jump-N-Carry features convenient side-mounted holsters with cable tracks
for easy cable and clamp management. Always re-wrap cables and re-holster the
clamps after each use.
• The Jump-N-Carry contains the latest technology with its twin sealed,
non-spillable battery and may be stored in any position.
Press the red switch to momentarily activate the battery status gauge. The gauge is an
approximate indicator of the battery's state of charge. When fully charged in the 12-volt
mode and disconnected from charging power, the gauge should read from 13-13.5 Volts.
Note: Upon initial purchase, charge your Jump-N-Carry for a minimum of 24 hours.
Explosion risk! Never charge a unit that was exposed to mismatched voltage (set to
12V but connected to a 24V system). Such units should be taken out of service and
have the batteries replaced prior to further use (see Jump Starting Instructions).
VERIFY THE FOLLOWING PRIOR TO CHARGING:
- Two pin connector and cable are not damaged.
- The voltage selector is disconnected and all connectors are in good working order.
- Clamps, jaws, and cables are in their proper storage location.
FEATURES
BATTERY STATUS GAUGE
RECHARGING
WARNING
There are two ways to charge your Jump-N-Carry.
The recommended method is recharging using AC
power, where the provided 2-pin extension cord
is connected to the built-in charger. An alternative
method is through the DC power outlet using the
provided 12 Volt Male-Male Extension Cord. When
the DC (12V) charging method is used, care must
be taken not to overcharge the Jump-N-Carry, as
noted.
Charging using the built-in charger (recommended
method). With this method, the provided 2-pin
extension cord is connected to the Jump-N-Carry
through the built-in charger located on the front of
the unit. Only use the provided extension cord when
charging the unit.
4

Publicidad

loading