ELECTRICAL INFORMATION
GUIDELINES AND RECOMMENDATIONS
FOR EXTENSION CORDS
When using an extension cord, be sure to use one heavy
enough to carry the current your product will draw. An
undersized cord will cause a drop in line voltage resulting in
loss of power and overheating. The table below shows the
correct size to be used according to cord length and ampere
rating. When in doubt, use a heavier cord. The smaller
the gauge number, the heavier the cord.
REQUIRED GAUGE FOR EXTENSION CORDS
AMPERAGE
25 ft.
18 gauge
5A
KNOW YOUR DRILL PRESS
TOOL PURPOSE
Drill presses are mainly used to drill clean, precise cylindrical holes into workpieces or enlarge existing holes. You may also
find other uses for your drill press such as reaming, countersinking, counter boring, tapping, etc. Refer to the diagram below
and on page 10 to become familiarized with the parts and controls of your drill press.
22
21
20
19
16
15
Various drill bits,
vises, clamps and
other accessories
can be purchased
from www.knova.com.mx
50 ft.
100 ft.
16 gauge
16 gauge
1
2
3
4
5
18
17
14
13
Fig. 2
1. Examine extension cord before use. Make sure your
extension cord is properly wired and in good condition.
Always replace a damaged extension cord or have it
repaired by a qualified person before using it.
2. Do not abuse extension cord. Do not pull on cord to
disconnect from receptacle; always disconnect by pulling
on plug. Disconnect the extension cord from the
receptacle before disconnecting the product from the
extension cord. Protect your extension cords from sharp
objects, excessive heat and damp/wet areas.
3. Use a separate electrical circuit for your tool. This circuit
150 ft.
must not be less than a 12-gauge wire and should be
protected with a 15A time-delayed fuse. Before connecting
14 gauge
the motor to the power line, make sure the switch is in the
OFF position and the electric current is rated the same as
the current stamped on the motor nameplate. Running at
a lower voltage will damage the motor.
6
7
9
10
4
1. Digital speed readout
2. ON / OFF switch
3. Depth scale
4. Chuck
5. Table
6. Feed handles
8
7. Housing cover screw
8. Housing cover
9. Column
10. Rack
11. Crank handle
23
12. Column support
13. Base
14. Table lock handle
15. Bevel lock bolt
16. Bevel scale
17. Laser ON / OFF switch
18. LED worklight switch
19. Extension wing with
11
integrated rollers
20. Support lock handle
12
21. Speed control handle
22. Power cord
23. Chuck key storage