ASSEMBLY AND ADJUSTMENTS
UNPACKING
With the help of a friend or trustworthy foe, carefully remove the drill press from the packaging. Make sure to take out all
contents and accessories. Do not discard the packaging until the drill press is completely assembled.
Before using the drill press, you must assemble the unit using the instructions in this section. Check your packing list against
the diagram below. If any part is damaged or missing, please contact our customer service at 55 5272 4808, M-F 8-5 CST or
e-mail us at centrodeservicio@knova.com.mx
CLEANING THE WORK TABLE SURFACE
Your drill press comes protected with a layer of anti-rust coating on its exposed (non-painted) metal surfaces. Clean the
rust-protected surfaces using a soft cloth, moistened with kerosene. Do not use gasoline, or cellulose-based solvents such
as paint thinner or lacquer thinner, as these will damage the painted surfaces. After cleaning, apply a light coat of
good-quality paste wax to the table and column to prevent rust. Wipe all parts thoroughly with a clean, dry cloth.
PACKING LIST
Check your packing list against the diagram below. If any part is damaged or missing, please contact our customer service at
55 5272 4808, M-F 8-5 CST or e-mail us at centrodeservicio@knova.com.mx and DO NOT plug the drill press in or turn ON.
1
14
17
16
1. Head / motor assembly
2. Column assembly
3. Table
4. Base
5. Chuck arbor
6. Chuck
12
15
7. Extension wing
with integrated rollers
8. Chuck key
9. Wing knobs (2)
10. Table lock handles (2)
11. Hex head bolts (4)
13
10
11
5
2
8
9
12. Table crank handle
13. Hex wrenches (3mm & 4mm)
14. Feed handles (3)
15. LED bulb
16. Wedge
17. Speed handle
3
4
5
6
7