Publicidad
Idiomas disponibles
Idiomas disponibles
Thank you for purchasing this ECO RESORT safe. We advise
you to read the instructions before you install and use the safe
to prevent it from being used improperly and thus voiding the
guarantee.
PRODUCT FEATURES
FRONT DIAGRAM OF THE SAFE
1. Knob.
2. Plastic cover – emergency lock.
3. Numeric keypad.
4. Battery case
5. Power switch
1
4
OPENING THE SAFE FOR THE FIRST TIME AND
INSTALLING THE BATTERIES
The safe is open by default. Remove the battery case lid
located on the back of the door and put in four 1.5 V batteries
(AA), being sure to line up the polarities correctly.
If the safe is closed when you receive it, by some exceptional
circumstance, follow the instructions in the "Emergency
Opening" section (points 1-3) before removing the battery
case lid and putting in the batteries.
The safe will be activated by default when sent, with the lock
in the "ON" position. If the safe is being used on a rental basis,
you should request the corresponding key from the factory. If
2
3
5
you have the key, insert it into the power switch and turn it until
the direction of the lock opening is lined up with the green dot
(in any other position, the safe will be disconnected). Bear in
mind that the lock will be in the "ON" position by default.
On
PROGRAMMING SUPERUSER CODE
The default superuser code for opening the safe is 111111
or 654321 (according to production batch, try both options).
For your security, it´s important that you change it and set the
code as you desire. Complete the following steps to change it:
• With the door open, press "00" and the "LOCK" button.
• Type the old superuser code and then press the "LOCK"
button.
• Input any 6 digits you like as a new superuser code and
press "LOCK".
• Retype your new superuser code and press the "LOCK"
button to confirm. A beep will indica¬te that the personal
code has been accepted and saved.
CLOSING
To close the safe, push the door closed, input the code that
you want (4 digits) and turn the knob counterclockwise.
OPENING
To open the safe, enter the same code used for closing,
followed by the "LOCK" button. A green light will turn on, then
you can turn the knob clockwise to open the door.
If you enter an incorrect code, you will hear 2 short loud beeps.
After 5 unsuccessful attempts, the lock will be blocked for
5 minutes, with the red LED flashing every 5 seconds until
the blocking time is finished. (Note also that if any button is
pressed during this time, the safe will produce a long beep).
En
Off
Publicidad
