Horizon Global 76597 Instrucciones De Instalación página 6

2b.) Using a flat head screw driver, from inside the rear wheel well, remove the
top rivet located just below the seam of bumper fascia. (1) per side. Do not
remove the bottom (2) rivets from wheel well area. Note: The factory
rivets cannot be reused. Four (4) replacement rivets are supplied, (2)
required, (2) spare.
2d.) If equipped, disconnect all wiring harnesses from fascia and carefully set
fascia aside.
©2022 Horizon Global™ Corp - Printed in Mexico
2c. Remove fascia - Using a flat head screw driver, from inside the rear wheel
well, remove the top rivet located just below the seam of bumper fascia.
(1) per side. Do not remove the bottom (2) rivets from wheel well area.
Note: The factory rivets cannot be reused. Four (4) replacement rivets
are supplied, (2) required, (2) spare.
3. Remove bumper beam – using a 14mm socket with extension, remove (2)
M10 flange hex nuts and (4) M10 hex bolts from bumper beam.
Sheet 6 of 27 76597NP 6/15/22 Rev. A