Horizon Global 76597 Instrucciones De Instalación página 7

3. Remove bumper beam continued - If equipped, disconnect the blind spot
monitor wire from top of bumper beam. Set bumper beam aside. Keep
hex flange nuts for hitch installation. Return factory hex bolts to vehicle
owner. See Figure 1.
5. Install Hitch and Bumper beam - Raise the hitch into position, inserting the tabs into the frame rail. Fishwire 7/16" carriage bolts ①and spacers ② into place
through the hole in the side plate and out the bottom of the frame rail, attach 7/16 flatwashers ③ , lockwashers ④, and nuts ⑤onto the carriage bolts See Figure
1. Install the bumper over the hitch, loosely install (2) M10 nuts ⑨ and 3/8" conical washers (teeth side toward hitch) ⑧ onto the studs, and (4) M10 hex bolts ⑦
and 3/8"conical washers ⑧ into weldnuts in end panel. If equipped, reconnect blind spot monitor wire to top of bumper.
©2022 Horizon Global™ Corp - Printed in Mexico
4. Apply sealant - apply silicone sealant to both hitch bracket mounting
surfaces. See Figure 2.
Not included
Sheet 7 of 27 76597NP 6/15/22 Rev. A