Foppapedretti Divo Manual De Instrucciones página 28

SAFETY HARNESS
Apply the brake before placing your baby in the pushchair.
Release the buckle (fig. 36): press button "a" and remove the components
Fasten the buckle (fig. 37): by inserting part A in part B, a click will indicate that it has been
fastened correctly.
WARNING: Never use the crutch strap without the lap belt.
WARNING: for babies under 6 months of age, the backrest must be only in the fully reclined, horizontal position at all
times, seat reaward facing (fig. 34).
WARNING: If baby is less than 6 months old, the harness belts must first be inserted through the lower slots and then
through the rings of the harness regulating buckle (fig. 35).
FOLDING THE STROLLER
Before folding the stroller, ensure that:
• The backrest is adjusted to the vertical position
• The canopy is closed back up
• The front wheels are in swivel mode.
Push the stroller forwards to direct the front wheels longitudinally.
Lift up the lever "a" and at the same time push downwards (fig. 38).
Move button "a" to the left, as shown in the figure, while pressing button "b" at the same time.
Fold the handlebar downwards(fig. 39). IMPORTANT: hold the handlebar until it is on the ground.
Bring the front wheel chassis towards the back.
Fold up the footrest.
Make sure it is closed properly.
USING THE TRAVEL SYSTEM ACCESSORIES
The TALENT pushchair can be used with the following travel system accessories, TALENT carrycot and TALENT infant car
seat. Remove the seat from the chassis (see the paragraph "Fitting the seat").
USING THE INFANT CAR SEAT AND CARRYCOT TRAVEL SYSTEM ACCESSORIES
IMPORTANT: the travel system accessories must be secured to the chassis only in the parent facing.
NAVICELLA MORBIDA
EN 1466:2014 + AC:2015
ASSEMBLING THE FRAME
• Lift up the handle, a click will indicate that it is locked in the vertical position. Make sure that it is locked (fig. 43).
• Press the bottom of the carrycot downwards and at the same time pull the handle upwards to raise the sides of the
carrycot (fig. 44).
• Pull the frame support brackets towards the outside of the carrycot, using the straps, until they lock into the 4 clips.
Make sure that the brackets are locked into the 4 clips (fig. 45, 46).
• Fold the fabric on the side towards the inside of the carrycot, attach the Velcro in the lower part along the inner edge.
Make sure that the fabric is properly secured with Velcro and that there are no openings along the side (fig. 47).
• Place the mattress inside the carrycot (fig. 48).
ASSEMBLING THE HOOD
Place the hood on the handle, wrap the front fabric of the hood around the handle, attach and close the zip. Attach the
press studs (fig. 49, 50).
(fig. 38, 39)
• ENGLISH •
USE
(fig. 40, 41)
28