Publicidad
IO-Link Data Dictionary
10.02.03.00394
IO-Link Implementation
Vendor ID
Device ID
SIO-Mode
IO-Link Revision
IO-Link Bitrate
Minimum Cycle Time
Process Data Input
Process Data Output
Process Data
Process data In
Reserved
Device Status Overall
PD in byte 0
Device Status
SP2 (part present)
SP1 (air saving function)
PD in byte 1
SP3 (part detached)
CM-Autoset
Reserved
PD in byte 2
Errors High-Byte
PD in byte 3
Errors Low-Byte
PD in byte 4
Warnings High-Byte
Bits
Access
0...3
ro
4..5
ro
6..7
ro
0
ro
1
ro
2
ro
3
ro
4..7
ro
0..7
ro
0..7
ro
0..7
ro
J. Schmalz GmbH
Johannes-Schmalz-Str. 1, D 72293 Glatten
Tel.: +49(0)7443/2403-0
Fax: +49(0)7443/2403-259
234 (0xEA)
100280 (0x0187B8)
yes
1.1 (compatible with 1.0)
38.4 kBit/sec (COM2)
7 ms
16 bytes
4 bytes
Remark
Reserviert
00 - [green] Device is working optimally, vacuum is below SP2
01 - [yellow] Device is working optimally, vacuum is above SP2
10 - [orange] Device is working but there are warnings
11 - [red] Device is not working properly
00 - [green] Device is working optimally, vacuum is below SP2
01 - [yellow] Device is working optimally, vacuum is above SP2
10 - [orange] Device is working but there are warnings
11 - [red] Device is not working properly
Vacuum is above SP2 & not yet below rP2
Vacuum is above SP1 & not yet below rP1
The part has been detached after a suction cycle
Acknowledge that the Autoset function has been completed
not used
Bit 0 = Short circuit at OUT2
Bit 1 = reserved
Bit 2 = reserved
Bit 3 = Measurement range overrun
Bit 4 = reserved
Bit 5 = reserved
Bit 6 = reserved
Bit 7 = IO-Link communication interruption
Bit 0 = IO-Link startup check: data corruption
Bit 1 = reserved
Bit 2 = Primary voltage too low
Bit 3 = Primary voltage too high
Bit 4 = Auxiliary voltage too low
Bit 5 = reserved
Bit 6 = reserved
Bit 7 = reserved
Bit 0 = General input pressure out of operating range
Bit 1 = reserved
Bit 2 = reserved
Bit 3 = reserved
Bit 4 = reserved
Bit 5 = reserved
Bit 6 = reserved
Bit 7 = reserved
RECB MATCH 1-C
07.04.2022
Publicidad
